How to set up the X431 V 8 inch wifi bluetooth

How to set up wifi and bluetooth in 2017 Launch X431 V 8 inch vehicle diagnostic scan tool? Here is the WiFi and Bluetooth setup guide for your reference.

Part 1: How to set up Wi-Fi in the Launch X431 V 8 inch scan tool

Note: If you don’t need to use Wi-Fi for a while, you can turn it off to conserve

battery life.

X-431 V has built-in Wi-Fi that can be used to get online. Once you’re online,

you can register your X-431 V, browse the Internet, get apps, send email and

check for software updates.

I. Connect to a Wi-Fi network

1. On the home screen, tap Settings > WLAN.

2. Slide the Wi-Fi switch to ON, X-431 V will start searching for available

wireless networks.

3. Select a wireless network,

– If the chosen network is open, X-431 V will connect automatically;

– If the selected network is encrypted, a network password will need to be

entered.

4. When “Connected” appears, tap the Enter button to exit and return to the home screen.

Note: When Wi-Fi is not required, this should be disabled to conserve battery

Power.

Once it is connected successfully, tap the Wi-Fi network from the list to view its

name, link speed, security type, IP address etc.

When this tool is in range, it will connect to the previously linked network

Automatically.

II. Disconnect from a Wi-Fi network

1. On home screen, tap Settings > WLAN.

2. Tap the network with a Connected status, then tap “Disconnect”

III. Vehicle diagnosis via WiFi

How to set up the X431 V 8 inch wifi bluetooth-1

Part 2: How to perform Bluetooth setting in the new LaunchX431 V scan tool

I. Bluetooth setting

Enter X-431 V Bluetooth setting screen (”Settings” –> “Bluetooth”), slide the

Bluetooth switch to ON and X-431 V will start searching available Bluetooth

device, tap the desired connector to pair.

By default, the Bluetooth name is 98549*****00 (where ***** stands for 5 digits.).

Note: In case no Bluetooth setting is done before diagnostic software is launched,

you can also configure it while using the software.

II. Car diagnosis via Bluetooth

Tap –> “Diagnostic” to enter the vehicle selection page.

Take Demo as an example to demonstrate how to diagnose a vehicle.

1). Tap the “DEMO”, the following dialog box appears:

How to set up the X431 V 8 inch wifi bluetooth-2

2). Tap “DEMO” to ignore Bluetooth connection and jump to the DEMO system selection screen. (Note: No Bluetooth connection is required for DEMO program.)

How to set up the X431 V 8 inch wifi bluetooth-3

3). Tap “Engine”, the system will jump to the function menu.

How to set up the X431 V 8 inch wifi bluetooth-4

Read DTC

How to set up the X431 V 8 inch wifi bluetooth-5

Read Data Stream
How to set up the X431 V 8 inch wifi bluetooth-6

How to set up the X431 V 8 inch wifi bluetooth-7

Also, special functions and reset service are available.

Special functions:

Injector test, fuel pump test, purge control solenoid and so on.

Reset service:

Oil Reset Service, Steering Angle Calibration, Electronic Parking Brake Reset, Battery Register/Maintenance, ABS Bleed, Electronic Throttle Position Reset/Learn, Diesel Particulate Filter (DPF) Regeneration, Tire Pressure Monitoring System Reset

Be the first to comment

Leave a Reply

Your email address will not be published.


*