How Autel MaxiSys Pro MS908P do MB SCN coding in 3 steps?

Many people know that Benz SCN Coding Service will charge about $150 at a time, but with Autel MaxiSys Pro MS908P you can do it easily! Here in this post, I will show you how to do Mercedes Benz SCN coding in 3 steps.

Why we need to do SCN coding?
When replacing or flashing ME control unit or new Transmission control unit we must get new SCN, that is to say SCN coding.

How Autel Tools

Autel MaxiSYS MS908P Pro do MB SCN coding in 3 steps?

6.1

Step1. You should first connect Autel MS908P to J2534 ECU programming device and Benz car. Then start Autel MS908P and choose “Diagnostics”→ “Benz”→ “Automatic selection”

6.2

6.3

6.4

Then turn on ignition and wait a minute to read VIN. After read click “OK”.

6.5

Step2. Click “Programming” on main menu, next click “ME-SFI-Gasoline engine control”.

6.6

6.7
Click “Control module programming”→ “NEXT”→ “OK”→ “OK”.

6.8

6.9

Step3. Click “SCN coding”, you can see two steps.

6.10

6.11

Click “Step1”, soon you will see “Get SCN data from sever completed”. Then click “Step2”, wait a minute and you will see “Perform SCN coding completed”. Now you successfully use Autel MaxiSYS MS908P Pro to do Benz SCN coding in 3 steps.

6.12

6.13

6.14

Of course, Autonumen.com Autel MaxiSYS MS908P Pro not only can do SCN coding but also has many other functions like diagnostics, ECU coding and flash programming, J2534 Reprogramming and so on. It covers more than 40 US, Asian and European vehicle makes till 2016.

Be the first to comment

Leave a Reply

Your email address will not be published.


*