Instruction for Update and install V2.30 MB SD Connect C4 MUX

Good news! Star diagnostic firmware has come to the newest version V2.30 MB SD C4 with D-LINK WIFI Card, which is available at more compatible price. New mb sd c4 can read and clear fault code, read the live data of sensor and actuator, do coding and programming. And it supports wireless diagnose, K line,CAN BUS and UDS protocol.

Software version: 2015.07V
DELL D630 HDD/External HDD optional
SS162-D7/S7 External HDD

Operating system:
Dell D630 format HDD on Dell D630 PC
External HDD needs PC with CPU 2.0GHZ or above, 4GB memory or more.

How to update new Star diagnosis MB SD Connect Compact 4 MUX to V2.30?

1. Please prepare 6 AA5 batteries according to Step-by-Step Instruction for how to install MB SD C4 Batteries.

Note: Please do use brand new batteries with sufficient electricity; otherwise, you will fail to update the firmware.

Then, select the green cable to connect to your laptop and MB SD Connect Compact 4 diagnostic multiplexer, and use OBD cable to connect to MB SD C4 multiplexer and your vehicle. (If the vehicle cannot be connected, select OBD 12V power instead.)

2. Open the software “2012.09 DAS”.
Go to C:\ program files \ SDconnect Toolkit to check whether there are the three following files as the pic below shows.
If the files’ names are different from the pic shows, please correct the names the same as the pic shows.

3. Restart your computer.

4. Start to update the firmware according to how to update MB SD connect4 MUX.

How to install V2.30 Star diagnosis MB SD Connect Compact 4 ?

1. Pls install it on XP system and close anti-virus software

2. This tool need to set your computer’s IP,you can see all installation

Be the first to comment

Leave a Reply

Your email address will not be published.