Device is designed for verification, calibration and configuration of control devices i.e. tachographs installed on vehicles. It can be used as speed simulator for a tachographduring checking the speedometer and odometer.
Description
Digital Tachograph programming and calibrating tool truck tacho Mileage Correction Tool
Tachograph programmer (Tacho) is designed for verification, calibration and configuration of control devices (tachograph) when installed on vehicles. The device allows you to define the W figure determination on measuring track or rolling road, K figure measure, can be used as speed simulator for the tachograph when checking the speedometer and odometer.
The Tachograph programmer calibrates and programs all analogue and digital tachographs
Supports IMS (Independent Motion Signal / Second speed signal) parameters on DTCO 2.0, SE5000 Exakt Duo and EFAS-4.
Supports ‘VDO counter’ parameter on DTCO 2.0
You can use this one do many things, like Changing the mileage and add VIN number of trucks in the MTCO and Pairing the speed sensor.
The Tachograph programmer CD400 calibrates and programs all analogue and digital tachographs.
Supported Tachographs:
Analogs: KTCO 1314/1318, Motometer EGK100, FTCO 1319, MTCO 1324/1390, TSU 1391, VR2400.
Digitals: DTCO 1381 (DTCO® 2.1 active), SE5000 (Exakt Duo), SmarTach, EFAS-4.
Functions:
W figure determination on measuring track (with optional photo-cell) or rolling road.
K figure measure on KTCO 1314, KTCO 1318 and FTCO1319.
Parameter programming.
Activation and deactivation of IMS (Independent Motion Signal).
Activation and deactivation of VDO counter.
Odometer reset and adjustment (mileage correction).
Speed simulation and customizable automatic test diagram.
DTCS reading (Digital) and erasing.
Sensor pairing (KITAS activation).
Clock test.
Workshop card’s PIN recording and input through CD400.
Advantages:
No power connection nor battery charging required, the only tester powered by the tachograph itself.
Compact size, the smallest tachograph tester on the market.
User friendly, clear 4 lines menus, no training required.
Automatic tachograph model detection on power on.
Double accuracy of the W factor measure on track by detecting half pulses.
The only tester being able to reset the odometer and change the sender type on the VR2400.
Flash program memory, easy software upgrade using a serial port or USB serial adapter on any PC.
Supported Languages:
English, Deutsch, Español, Français, Nederlands, Português, Turkish, Romanian, Serbian, Russian
Kit included:
CD400 – tacho programmer
Cable for 1319
Cable for 13ХХ/1318, V.Root 8400
Cable for EGK-100
Cable for 1324
Cable for V.Root 2400
Cable for CA-RS232-1
Cable for digital tacho
Manual
Leave a Reply