CNH EST 9.3 conexión a modulo Isuzu con escáner CNH por protocolo KLINE

We are going to do a test with motor and suso cnh connects we open the program again here we are going to select a caterpillar I am going to select it cxb to connect to this motor and its.
CNH EST 9.3 conexión a modulo Isuzu con escáner CNH por protocolo KLINE

CNH EST 9.3 conexión a modulo Isuzu con escáner CNH por protocolo KLINE-1
But here the communication is going to come out. It woke up with the communication called kline no accept here as you can see the communication that line is working which is the one that connects its motors and its and we can see that it has been identified and that it is online we can see the codes are the codes that they show me in order to erase errors as it is the switch and the switch again we are going to give it an update to take up the communication again we have to move it it is taking and now show me the real codes young man here it is still connected I can disconnect it from the usb connect it to another bus here it shows the source that is not there connected and I go back and connected to another usb and here I connect 90 and as he connected me once again online we can see here he recognized me module again it is the connector I am going to pass it to another usb
CNH EST 9.3 conexión a modulo Isuzu con escáner CNH por protocolo KLINE-2
from the ones on the right side the same thing can happen

Be the first to comment

Leave a Reply

Your email address will not be published.


*