INPA K+DCAN cable vs ENET cable vs BMW ICOM A2 (icom next)

Any cost-effective DIY solution of BMW diagnostic/coding/programming?

First you should know which BMW TOOLS you need: K+DCAN or ENET or ICOM A2/ ICOM Next.
21.1
21.2

In summary,

It depends on your purpose (diagnostic or coding or programming) and model (Exx or Fxx or others).

For Coding, you need different Tools, NCS Expert / SP-Daten for E-Series and E-Sys / PSdZData for F-Series.

All Diagnosis and Coding can be done with cheap DCAN Cable for E-Series and cheap ENET Cable for F-Series.

For Programming (Flashing ECU’s with new Firmware), then you need ISTA/P for for both E-Series and F-Series cars, or you can use WinKFP for E-Series and E-Sys for F-Series. For E-Series Programming, you will need an ICOM, but for F-Series Programming, you can use ENET Cable.

For Exx- Series:

Interface = K+DCAN Cable (OBDII to USB) or ICOM

ECU Data Files = SP-Daten

NCS Expert = Coding Software

WinKFP = Programming (Flashing) Software

EDIABAS = Low-Level ECU Communication Software used by NCS Expert & WinKFP

For Fxx- / Ixx- / Gxx-Series, Mini, & Rolls-Royce:

Interface = ENET Cable (OBDII to RJ45 Ethernet) or ICOM

ECU Data Files = PSdZData

E-Sys = Coding Software

E-Sys = Programming (Flashing) Software

About: BMW ICOM

BMW diagnostic tool ICOM A (also ICOM A2, ICOM A3, ICOM Next A): main interface

ICOM B: adapter for programming multimedia in E series

ICOM C: adapter for old BMW with round 20 pin diagnostic plug

ICOM D: adapter for motorcycles

ISTA+ (AKA Rheingold or ISTA-D)

DIAGNOSTICS for All Vehicles

PROGRAMMING for F/I/G/RR & MINI, but requires an ICOM

ISTA-P

PROGRAMMING traditionally for all chassis, but is being phased out by August 2017, except for legacy E-series.

Replacement ECU’s must be NE

See more click:http://www.autonumen.com/

Be the first to comment

Leave a Reply

Your email address will not be published.


*