This is customer share about how to use BMW ICOM WinKFP to update BMW CIC module and how to generate BMW CIC& NBT FSC Code with ENET cable.
Disclaimer: You are on your own risk.
PRE STEPS: In the E87 DATEN folder, make sure to swap out the file CI63F1 from the E87 Folder. Then Load assembly line data into WINKFP (at first WINKFP should be setup for STD:OBD connection so you can do this part without having to connect to the car or ICOM).
Following steps:
0 – Move Car Key to position 1
1 – Connect BMW ICOM A2 to any available MOST (fiber optic) Connector. Connect the USB cable between it and the ICOM module.
2 – Connect OBD connector to ICOM Module.
3 – Connect ICOM to Laptop via Ethernet cable.
4 – Start up Itool Radar and Reserve the ICOM slot. (You’ll need to search for ITool Radar).
5 – I usually use the EasyConnect after ITOOL to select the MOST bus ASYNC setting and LOCK Icom.
6 – Start up WINKFP and select comfort mode
7 – Select Update ZUSB
8 – From the list, select CI62F1 first and click OK.
9 – Enter VIN
10 – Click DONE.
11 – In Next window, Click PROG-ZUSB.
12 – Blue bar will start – This step will take about 35-40 minutes. CIC screen will turn black and cic fan will be blowing at full speed.
13 -Select Update ZUSB again
14 – From the list, select CI63F1 and click OK.
15- Enter VIN
16 – Click DONE.
17 – In Next window, Click PROG-ZUSB.
18 – This step takes about 7-10 minutes.
19 – Lastly Select Update ZUSB again
20 – From the list, select CIA0F1 and click OK.
21 – Enter VIN
22 – Click DONE.
23 – In Next window, Click PROG-ZUSB.
24 – Screen might come up with BMW symbol and bootloader mode.
25 – This step takes about 45 minutes.
Once these steps are complete, CIC will boot up again and you’re done!
To generate BMW CIC& NBT FSC Code you need these:
1.FSC Code Generator software
2.BMW ENET cable
3.EDIABAS Tool32 software
Following Steps:
1) READ FSC
Open FSC Generator software on desktop
Click “Read FSC”
Select BMW chassis, e.g E-series
Click Connect then Read VIN
The software will display vehicle information
Click Read FSC (1B)
Click Save to File
Exit
2) DECODE FSC
Back to FSC MAP menu
Select DECODE FSC button
Click Load file and load dump bin file
Click “Search” and browse to C:/EC:APPS/a hex
Click Decode button
Finish decoding
3) GENERATE FSC
Back to FSC MAP menu
Select “GENERATE” button
Code has been generated
Open C:﹨EC:APPS﹨code.txt to check the FSC code
PS: If you fail o generate for NBT, try do following settings:
You can actually grab the 1B or DE file from E-sys by doing the following:
FSC Extended
Base variant 0x63 (For HU_CIC or HU_NBT)
Click Identify
Application ID 0x1B for (App ID 27 for CIC) 0xDE (App ID222 for NBT) <— This is the App for your Nav enabler
Upgrade Index 0x1
Move Store FSC from the left to the right
Click Read
Click Save and name the file FXXXXXX_0001B001.fsc for CIC or FXXXXXX_000DE001.fsc for NBT where FXXXXXX is your VIN.
Both CIC and NBT work.
www.autonumen.com
loading..
Leave a Reply